haowhe.blogg.se - Anygate router manual

Click “ Save Settings” again and that’s it! You have blocked people from stealing your network connection based on MAC address.

Be sure to scroll to the bottom to click “ Save Settings” when you are done. But I want to allow the other 2 addresses on the DHCP Active IP Table. Notice I left off the 00:17:9A:D0:03:3D MAC address because I don’t want that dude connecting to my router.

Add the MAC addresses you would like to allow on your network.

Clicking “ Enable” then “ Permit only” will enable only certain MAC addresses to connect.

I left the DCHP Active IP Table open and then back in the admin console clicked “ Wireless” > “ Wireless MAC Filter“.

I don’t know what computer is using the IP address of 192.168.1.101 with the MAC address of 00:17:9A:D0:03:3D, I need to block that guy!

Login into the admin console of the Linksys router and select “ Status” > “ Local Network“> “ DHCP Clients Table“. This provides a list of computers that have been using my wireless connection.

Select “ Save“, and the MAC Address is denied or allowed as specified in step 4.

Type the MAC Address using a colon or dash every two characters.

You could leave yourself without internet access and have to perform a factory reset on the router. Also be sure not to DENY the MAC Address you are currently using.

Note: Be sure to ALLOW the MAC address for the device you are currently using.

“ Allow access for ONLY the listed MAC addresses” if you wish to allow access to specific MAC Addresses.

“ Deny access for the listed MAC addresses” if you wish to block access to specific MAC Addresses.Select “ Troubleshooting” > “ DHCP client table“. This provides a list of computers that have been using my wireless connection.It is usually located by using “ 192.168.1.1” in the address field. Login into the admin console of the Linksys router via a web browser.